DTX FORUM

Got questions? The DTX community is here to help.

Message

The mail function has been disabled by an administrator.

  1. Kevin
  2. Sherlock Holmes
  3. DTX502 Series
  4. Wednesday, 21 February 2018
I have gone into Trigger type to insure RHH135 is chosen but still no luck. It just acts like a single zone cymbal and open / close does not trigger at all.

I have attached a picture of my hybrid kit (Hart Dynamics pads with Yamaha SD120S, PCY135, 155 and now RHH135).

Right now I have chosen DTX562 kit just to get in the ballpark since that should work with the RHH135 but no luck.

Would appreciate help. Thanks,

Dave
Attachments (1)
Accepted Answer Pending Moderation
0
Votes
Undo
1. What cables are you using and where are they plugged into?
2. Have you tried to plug the pad into, say, the ride input and check the zones?
Comment
There are no comments made yet.
  1. more than a month ago
  2. DTX502 Series
  3. # 1
Accepted Answer Pending Moderation
0
Votes
Undo
1. I am using the 2 cables that came with the RHH135
2. Plugging it into the Ride give me inconsistent Edge / Bell hits. Very odd behavior I would think. It still does not act like a clean 2 zone cymbal.
Comment
There are no comments made yet.
  1. more than a month ago
  2. DTX502 Series
  3. # 2
  • Page :
  • 1


There are no replies made for this post yet.
Be one of the first to reply to this post!
2021 © Yamaha Corporation of America and Yamaha Corporation. All rights reserved.