Anand
Anand
Online
Resolved
0 votes
Hi,

What is best way to connect a Bluetooth headphone to EAD10, without any latency.

TIA/Anand
In EAD10
Friday, January 10 2020, 11:19 AM
Share this post:
Responses (3)
  • Accepted Answer

    David
    David
    Offline
    Friday, January 10 2020, 01:54 PM - #Permalink
    Resolved
    0 votes
    No. It's Bluetooth that introduces latency,

    Just use wired headphones (I assume you're not running around the stage).

    If you really want wireless, use analogue.
    The reply is currently minimized Show
  • Accepted Answer

    Anand
    Anand
    Online
    Saturday, January 11 2020, 01:46 AM - #Permalink
    Resolved
    0 votes
    Hi David,

    Thanks for your response.

    To achieve good isolation I use Shure SE215 as IEM. Looking for option to connect it to EAD10 using its bluetooth cable. Wire which comes along with it is too short to reach module.

    What do you mean by use analogue.

    Thanks//Anand
    The reply is currently minimized Show
  • Accepted Answer

    Anand
    Anand
    Online
    Tuesday, January 14 2020, 05:35 AM - #Permalink
    Resolved
    0 votes
    Thanks IAN, exactly this is what I have done, if fact by chance I purchased same cable :-). Additionally I have switched tip to "Shure EATFL1-6 Triple Flange Sleeves" for better isolation.

    I think Bluetooth is a no go.

    Cheers...
    Like
    1
    • Ian
      one week ago
      Haha that's great!! Yea triple flange sleeves really block out sound. You can even try the yellow foam tips too.

      Bluetooth is probably a no go for most E-kit users for now.
    The reply is currently minimized Show
Your Reply