Jim
Jim
Offline
Resolved
0 votes
I bought a used DTX400k for my grandson to learn on. It’s in great condition but I noticed that the snare volume is lower than the other drum pads. I tried resetting to defaults but that didn’t help. I then went into Pad Volume mode mode and found the following settings:
Tom1 - 52
Tom2 - 52
Floor Tom - 53
Snare - 23

I tried resetting the snare volume to 54, but after a saved it and checked again, the snare volume showed 4. I tried setting it to other double digit numbers but it only seems to store the last digit entered.

How is the Pad Volume set?

Jim
Saturday, April 27 2019, 05:50 PM
Share this post:
Responses (2)
  • Accepted Answer

    David
    David
    Offline
    Monday, April 29 2019, 11:34 AM - #Permalink
    Resolved
    0 votes
    Volume is in the range 0-127. You look like you were setting the MIDI notes.

    https://i.snag.gy/N0pHsE.jpg
    The reply is currently minimized Show
  • Accepted Answer

    Jim
    Jim
    Offline
    Monday, April 29 2019, 01:14 PM - #Permalink
    Resolved
    0 votes
    David,
    That’s the procedure I tried. At Step 5, I pressed the 5 then the 4, to get a value of 54. However, when I went back and checked the setting, it only flashed 4. Regardless of the digits I press, it only seems to save the last one I enter.

    Thanks

    Jim
    The reply is currently minimized Show
Your Reply