Patrick
Patrick
Offline
Resolved
0 votes
My new gen4 ipad with touch app will not connect to my new dtx12. I have updated firmware, and am using lightning usb camera adapter and standard printer cable. DTX is set to MIDI (6-9)USB. What am I doing wrong? Please advise?
Sunday, February 03 2019, 12:40 PM
Share this post:
Responses (2)
  • Accepted Answer

    Jordan
    Jordan
    Offline
    Tuesday, February 05 2019, 05:49 PM - #Permalink
    Resolved
    0 votes
    Hi Patrick!

    1- You have everything updated
    2- You are certain you have the MIDI set to USB

    Just a quick note, the iPad and Multi12 do not function bi-directionally, meaning any changes you make on the iPad, you have to then send those into the Multi 12 using the arrow in and arrow out graphics on the bottom right hand side of the App screen.

    Also make sure you have a functional USB Chord connected to a camera connection kit.

    The video below describes the steps involved with getting the App to work with the M12 unit.

    https://www.yamahadtx.com/resource-categories/item/523-layering-voices-on-the-multi12

    Keep me posted Patrick!

    Jordan
    The reply is currently minimized Show
  • Accepted Answer

    Bob
    Bob
    Offline
    Wednesday, April 10 2019, 05:44 AM - #Permalink
    Resolved
    0 votes
    Try a factory reset via the utility menus. that's what did it for me.
    Also remove and reinstall the app.
    Turn on the DTX. Double check the midi/usb setting.
    Start the app.

    But the next time the app fails I'm selling this thing.
    It's too difficult to program without the app.
    The reply is currently minimized Show
Your Reply