tony
tony
Offline
Resolved
0 votes
Since I updated module ,snare not triggering as normal,it sometimes doesn’t sound for several stick hits!
Can any one please advise.
Thanks
Thursday, May 03 2018, 09:58 PM

Location [ View Larger Map ]

Share this post:

Accepted Answer

tony
tony
Offline
Friday, May 04 2018, 07:52 PM - #Permalink
Resolved
0 votes
Problem sorted when I updated module ,I didn’t recalibrate pads input level adjustment as described in manual,firing on all cylinders again,
Love this kit haven’t been back on my TD30 since I got hold of this engine,
In fact it’s on eBay ending tomorrow Td30 on a Td20 sx, great kit but Yamaha’s got me up on the gas
The reply is currently minimized Show
Responses (2)
  • Accepted Answer

    David
    David
    Offline
    Thursday, May 03 2018, 10:34 PM - #Permalink
    Resolved
    0 votes
    Few basics:
    1. swap for another pad to see if it's the pad.
    2. swap for another cable.
    3. test snare pad in different input,
    4. factory reset.]
    5. check trigger settings for the snare input are as you think they should be,

    Did you do a settings backup before the upgrade?
    The reply is currently minimized Show
  • Accepted Answer

    tony
    tony
    Offline
    Friday, May 04 2018, 06:31 AM - #Permalink
    Resolved
    0 votes
    Thanks David ,
    I just purchased 3 weeks ago, module was on v 1-03 I updated to latest 1-10 no probs ,I then added on the 30 free kits from Yamaha,again all was good, I didn’t save data befor update as I had nothing on module I wanted to keep,it only last couple of days snare has been misfiring
    I will go through your suggested list,

    Location [ View Larger Map ]

    The reply is currently minimized Show
Your Reply